Complete The Installation - Whirlpool W10325308A Instructions D'installation

4.
Secure pedestal to dryer
Position the pedestal toward the front of the dryer and install
the two remaining hex-head sheet metal screws. Do not tighten
completely. Now proceed to "Complete the pedestal installation".
COMPLETE THE PEDESTAL INSTALLATION
1.
Align sides of pedestal
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
2.
Prepare pedestal feet
The pedestal arrives with the feet tight against the bottom of the
pedestal. Using a 1/4" hex head ratchet or open-end wrench,
lower the feet approximately 1" (25 mm) away from the bottom
of the pedestal.
1"
(25 mm)
3.
Stand the washer/dryer upright
Tip the washer/dryer back to its upright position. Remove
any remaining packaging material. Set the pedestal box aside
for use when installing the pedestal on the dryer. Once both the
washer and dryer have been installed, dispose of/recycle all
packaging material.
Level the washer/dryer
1.
Move close to final location
Washer shown
Follow the installation instructions that came with your washer/
dryer to finish installing or reinstalling your washer/dryer (i.e.,
hoses, vents, etc.). Be sure to remove the shipping bolts from the
back of the washer, if not previously removed.
7