Before Installing Pedestal - Whirlpool W10325308A Instructions D'installation

2.
Remove pedestal drawer
Drawer slide
Hex-head screw
Using a 1/4" nut driver, remove the hex-head screws from both
drawer slides and save screws. Remove the drawer from the
slides and set aside. Push the slides back into the pedestal.
3.
Locate spacer pads
Spacer pads
The four spacer pads are installed on the top of the pedestal.
These pads reduce vibration between the pedestal and the
washer/dryer.

BEFORE INSTALLING PEDESTAL

IMPORTANT: If your washer and dryer are already installed, they
must be uninstalled.
Uninstalling your washer
NOTE: If the washer is to be transported, call your local service
center. To avoid suspension and structural damage, your
machine must be properly set up for relocation by a certified
technician.
1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord.
3. Slowly loosen the fill hoses at the faucets to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Remove the "HOT" and "COLD" fill hoses from the back of the
washer. Drain the water from the hoses into a bucket.
5. Remove the drain hose from the standpipe or laundry tub and
drain any water remaining in the hose into a bucket.
6. Pull the washer away from the wall so that you will have
enough space for the installation.
3