Device Assembly - Bartscher 150.1390 Mode D'emploi

Device assembly

•
Before the first use please clean all the detachable parts of the device (see pt. 6.2
„Cleaning").
•
Place the engine block (8) on a flat, stable surface. Assembly, on the engine block (8)
the drive attachment (6), so that it is properly locked in the engine drive (10).
•
Assembly outlet attachment (5) on the drive attachment (6).
•
Assembly fixing disc (4) and cutting disc (3).
NOTE!
The cutting disc may be attached in different ways: for cutting and for slicing of
vegetables.
•
Put cover (2) on outlet attachment (5) and mount it with both safety locks (7), by
pushing them up until they become locked in appropriate places on the cover. When
the safety locks are correctly assembled the safety switch in engine block activates.
If safety locks are released, the safety switch deactivates and the engine stops
operating.
CAUTION!
The device is equipped with safety switch and may only be turned on when both
safety locks are in a proper position (locked correctly).
•
Place the food container under the outlet of the outlet attachment (5) & cover (2).
Operation
•
Make sure that the cutter attachment has been assembled properly and completely.
•
Wash the vegetables or fruit and cut them in proper size pieces which will fit the feed
•
chute attachment of the cutter.
•
Plug the device to the proper single mains socket.
•
Use switch (9) to select a suitable speed rate:
upper switch position „1" means high speed,
lower switch position „2" is for low speed setting.
position „
•
After setting the required speed, place the suitable fruit or vegetables in feed chute
and push down with the pusher (1).
" turns the device off.
- 23 -