LEGRAND Wattstopper EOSW Série Instructions D'installation page 3

In Configuration mode, you can change the Time Delay "T", Operation Mode "O", or perform the load assignment or bind the loads.
Step 1 Enter Configuration Mode
Press and Hold "Configuration" Button "C" for 3 Seconds
• For EOSW-111 Load 1 turns ON. (Load 1 is now active.)
• For EOSW-112 Load 1 turns ON and Load 2 turns OFF.(Load 1 is now active.)
• "Time Delay" and "Operating Mode" LED's are lit to indicate their current settings
for the specific load.
Step 2 Modifying "Time Delay"
Tap the "Time Delay" Button "T" to cycle through options of 30min/15min/5min
descending. The corresponding Time Delay LED is lit to confirm time delay selection
for the specific load.
Step 3 Modifying "Operating Mode"
Tap the "Operating Mode" Button "O" to alternate between "Manual-On" and
"Automatic-On" settings where corresponding LED confirms operating mode selection
for the specific load.
Step 4 Modfying Load 2 Parameters (EOSW-112)
To modify Load 2 settings:
Tap "Configuration" Button "C" once to alternate between Loads
• Load 2 turns ON and Load 1 turns OFF. (Load 2 is now active.)
• The load status LED that is lit corresponds to the Load being modified.
• Repeat steps 2 and 3.
Step 5 Exit "Configuration" Mode
Press and hold the "Configuration" Button "C"on the receiver until the green LED's turn
off, approximately 3 seconds, to exit Configuration mode.
SETTING LOAD PARAMETERS ON THE RECEIVER
3
EOSW-112
"Load 1 Status"
Blue LED ON
"Load 2 Status"
Blue LED Off
Configuration
Button
EOSW-112
Time
Delay
LEDs
Time Delay
Button
EOSW-112
Operating
Mode Button
EOSW-112
"Load 1 Status"
Blue LED OFF
"Load 2 Status"
Blue LED ON
Configuration
Button
"Load Status"
Blue LEDS
"Load Status"
Blue LEDS