LEGRAND Wattstopper EOSW Série Instructions D'installation page 2

Time Delay: Three Green Time Delay LEDs on the
left-side of the switch display the selected time delay
value of 30, 15 or 5 minutes. When a LED is ON, its
corresponded value is active. Each tap of the 'T' button
cycles through the values.
Operating Mode: Two Green Operating Mode LEDs
display the selected operating mode. Each tap of the
'O' button alternates between "Manual-On (M)" and
"Automatic-On (A)".
Load Status: Each Load (Switch) Button has a Blue load
status LED. The LED is solid ON when the load paired to
that button is turned ON, and DIM when the load is OFF.
Tap a Load (Switch) Button to toggle loads ON/OFF.
Pairing Mode: One Green Pairing LED displays when in
Pairing mode. Each tap of the 'P' button cycles through
the loads.
Configuration: Tap the 'C' button to enter configuration mode and set load parameters on the receiver.
After connecting the load and line wires, secure the EOSW to the wallbox using the two screws that are provided. Please, do not force
or overtorque unit with torque screw driver. To do so may damage the unit.
BUTTONS AND LED INDICATORS
MOUNTING AND WIRING
(8-10 in-lb of torque is
adequate to secure unit.)
EOSW-111 Series
3 "Time Delay"
Green LEDs
Time Delay
Button
2 "Operating Mode"
Green LEDs
Operating
Mode" Button
Neutral
Line Black
Neutral White
Ground Green
Neutral
Line Black
Neutral White
Ground Green
2
EOSW-112 Series
"Load Status"
Blue LEDs
EOSW-111
Red
Primary
Load
EOSW-112
Red
Primary
Load
Brown
Secondary
Load
Load Button
1 "Pairing" Green LED
Pairing Button
Load Button
Configuration Button