Technical Data; Service And Maintenance - Kawasaki K-EHD 900 Traduction De La Notice Originale

General
GB
- The hammer drill is equipped with a vibration
cushioned handle.
- Always hold the drill/chisel hammer with both
hands.
- Make sure that there is good ventilation when
working.
- Don't drill into asbestos cement.
- When drilling metal, make a punch mark on the
drilling location as a precaution.
- Start the machine running slowly. Press the on/
off switch slowly.
- If possible, use a cooling agent.
- Always keep the ventilation slits of the machine
clean and dust-free.
If necessary, clean with a soft brush.
- Only use bits or chisels with an SDS socket.
- Be aware of the sharpness of the bits and chisels.
- Before starting, put the drill or chisel onto the
drilling/chiselling position and apply pressure.

Service and Maintenance

- Before performing any work on the equipment,
pull the power plug.
- Use a damp cloth to clean the plastic elements.
Do not use any cleansers, solvents, or pointed
objects.
- Regularly clean any dust that is stuck to the
ventilation openings and moving parts with a soft
brush or a paint brush.
- The hammer drill must be lubricated with the
grease that is provided after approximately 25
10
hours of operation.
- Use a cam wrench to remove the cover plate (5)
on the upper part of the machine.
- Use approximately 50 g of grease to lubricate all
mechanical parts that you can reach.
- Close the cover plate.
- If necessary, have an electrician replace the
carbon brushes.

Technical Data

Voltage:
Frequency:
Power consumption:
Idling speed:
Blow rate:
Tool socket:
Drilling performance:
Weight:
Continuous sound pressure level L
Sound power level L :
WA
Vibration emission value for "hammers
In concrete "a : 26,418 m / s
h, HD
Vibration emission value in "chiseling"
2
A : 23,634 m / s
h, CHeq
2
Uncertainty K: 1,5 m / s
The noise that is generated at the workplace can
exceed 85 db (A).
Therefore, wear ear protection.
Repairs
Only use accessories and spare parts
recommended by the manufacturer. If the
equipment should fail some day in spite of our
quality controls and your maintenance, only have
it repaired by an authorised electrician.
220-240 V~
50 Hz
900 W
-1
880 min
-1
4300 min
SDS Plus
Ø 26 mm Max.
3,6 Kg
:
PA
94,64 dB(A), K=3dB(A)
105,64 dB(A), K=3dB(A)
2