Safety Information - Kawasaki K-EHD 900 Traduction De La Notice Originale

Safety Information

GB
The equipment complies with the safety
regulations required for electrical
equipment.
Read through the instructions for use before
starting up the equipment.
Improper use can lead to personal injury and
property damage. Persons, who are not familiar
with the instructions, may not operate the
equipment. Keep the instructions for use in safe
custody.
Children and youths are not permitted to operate
the equipment.
Use According to Specifications
The device is designed for hammer drilling in
concrete, bricks, and rock, and for drilling into
wood, metal, ceramic, and plastic.
The manufacture assumes no liability whatsoever
for improper use or if the machine has been
tampered with.
Give equal attention to the safety instructions,
assembly and operating instructions as well as
prevailing accident preventions regulations.
Safety Information
Keep your work area clean and well lit to prevent
accidents.
Don't use electric devices close to flammable
liquids or gasses or in wet or damp environments.
If you fail to observe this, there is a danger of fire
or explosion.
Never leave the device running unattended.
Never use the device when you are tired or lack
concentration or if your reactions are impaired
due to consumption of alcohol or medication.
Lack of attention can lead to serious injury.
Keep the tools clean and in good working order
8
in order to be able to work better and safer.
Don't wear bulky clothing or jewellery.
Make sure you can stand stably and have shoes
that won't slip.
Use a head cover if you have long hair.
Loose clothing, jewellery, and long hair can
become entangled in moving parts.
Always wear safety goggles.
Wear a dust mask when working with materials
that produce dust.
Wear ear protection if a lot of noise is produced.
Persons using the machines must not be
distracted.
This could cause one to lose control over the tool.
Don't use any device that has a faulty on/off
switch. An electric tool that can no longer be
switched on or off is dangerous and must be
repaired.
Always switch the device on before coming into
contact with the material.
Remove keys and adjusting tools before switching
on the device.
Never overload the machine. If the speed drops,
unload the machine or switch it off. You will work
safer and better with the appropriate electric tool
in a specific area of application.
Stop the workpiece from turning, for example
with a clamping device or a vice. Don't work on
any workpiece that is too small to clamp in place.
If you hold the workpiece with your hand, then
you can't operate the tool safely.
Keep electric tools out of the reach of children.
Only use accessories recommended by the
manufacturer.