LG PACP5A000 Manuel D'installation page 16

INSTALLING ACP 5
16
Turning on the ACP 5
Turn on the ACP 5 to set the network environment of the ACP 5.
When the power switch is turned on, the ACP 5 booting screen is displayed on the LCD as
shown at the following figure, and when booting is completed, the initial ACP 5 screen is
displayed.
Wa i t
NOTE
!
Software version
The software version of the current ACP 5 is displayed at the
initial ACP 5 screen.
Also, the software version may be different according to the
manufacturing date of the ACP 5.
Entering into the environment setup mode
Press [SET] button of the ACP 5 to enter into the environment setup mode of the ACP 5.
When the [SET] button is pressed for the first time, the menu to set the IP address is displayed
as shown below.
Press up/down(▲, ▼) button to place the arrow on the desired function.
• When you select [Network Info] and press [SET] button, it enters the No. 1 menu in the
following figure. In [Network Info] menu, input the network information such as IP address of
the ACP 5.
• When you select [Function] and press [SET] button, it enters the No. 2 menu in the following
figure. In [Function] menu, ACP 5 software service function is supported.
A C P 5
S W v e r .
I P 1 9 2 . 1 6 8 . 0 0 1 . 1 0 0
G W 1 9 2 . 1 6 8 . 0 0 1 . 0 0 1
CAUTION
!
• [Function] menu is used by the system air conditioner service technician, so user shall
never use this function.
• If this function is incorrectly used, it may cause disorder of the ACP 5.
f o r b o o t i n g . . . .
> Network Info
Function
[ S E ] T
> Network Info
1 . 0 0 . 0
Function
[ ]
A C P 5
S W v e r . 1 . 0 0 . 0
I P 1 9 2 . 1 6 8 . 0 0 1 . 1 0 0
G W 1 9 2 . 1 6 8 . 0 0 1 . 0 0 1
A C P 5
S W v e r .
I P 1 9 2 . 1 6 8 . 0 0 1 . 1 0 0
G W 1 9 2 . 1 6 8 . 0 0 1 . 0 0 1
1
[ Network Info ]
IP 000.000.000.000
GW 000.000.000.000
MS 000.000.000.000
[ [ S E ] T
MC 000000:00:00:00
DHCP NO
2
[ Function ]
S/W update
[ ]
DB back up
DB recover
Data Logging
Language
Net Test
HTTPS Port Reset
1 . 0 0 . 0