LG PACP5A000 Manuel D'installation page 15

Connecting ACP 5 and PC
It is the case of connecting ACP 5 and PC
directly.
In such case, Ethernet cable shall be
connected as a cross cable.
Use Ethernet cable to connect to LAN port of
the ACP 5.
A B A B A B A B A B A B + - + -
INSTALLING ACP 5
Setting the ACP 5 network
address
After connecting the ACP 5 to various devices
via the cable, the network environment of the
ACP 5 should be set by driving the ACP 5. The
following information should be set for using
the ACP 5.
• IP address of the ACP 5
• Gateway address
• Net mask
CAUTION
!
Setting the network environment
information
If the above information is not entered,
the communication error may be occurred
or it may be impossible to control by the
ACP 5. So, be careful to correctly input.
Before configuring the ACP 5
environment
The network environment of the ACP 5 can be
set by the LCD and the buttons at the front
side of the ACP 5.
The current ACP 5 information and the menu
are displayed on the LCD, and the menu can
be changed and selected by pressing and
button and Up/Down/Left/Right
(▲, ▼, ◀, ▶) buttons.
PACP5A000
PACP5A000
15