Before Using For The First Time - Inventum AC901 Mode D'emploi

3

before using for the first time

Follow these instructions when using the appliance for the first time: Carefully unpack the air conditioner and all accessories
and remove all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of the reach of children.
After unpacking the appliance, check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient ventilation. Check
that all mentioned accessories have been supplied.
Clean the air conditioner with a slightly damp cloth.
Prior to connecting the appliance, check that:
• the connection voltage corresponds with what is stated on the information plate;
• the socket and cord are suitable for the appliance;
• the plug of the cord fits in the socket;
• the appliance is placed on a stable and flat surface.
INSTALLATION
A mobile air conditioner must be placed on a flat surface with sufficient room all
around. Do not block the air outlet and ensure a free space of minimum 30 cm
around the air conditioner.
After placing the appliance in a straight position, allow it to stand for at least 2
hours before inserting the plug in the socket.
• Screw an end of the discharge hose [ a ] in the square connector [ b ].
• Place the square connector [ b ] in the fixing clamp [ c ] on the rear of the air conditioner.
• Ensure a good air circulation and keep at least 30 cm around the air conditioner free.
• Hang the other end of the discharge hose to the outside. Ensure a free passage of the hose. Close the window
or door to the extent possible.
REMARK: Optimum operation of the air conditioner depends on the length of the discharge hose and the number of
bends. Try to limit both. The supplied flexible discharge hose has a maximum length of approx. 150 cm and corresponds
with the capacity of the air conditioner. The use of any other hoses or extensions could cause failures in the appliance.
The air should be able to flow without any hindrance, or else this could cause overheating of
the appliance or condensation of water in the air discharge hose. Therefore make sure there are no kinks or sharp bends
in the discharge hose. In order to reach an optimum result, the discharge hose should be
kept shorter than 1 metre during use of the air conditioner.
20
• English
c b
drain opening
a