Problems And Remedies; Technical Specifications - Inventum AC901 Mode D'emploi

6

problems and remedies

First check the following before submitting the air conditioner for repair.
Problem
The appliance does not switch on
when pressing the on/off key.
The appliance does not cool
sufficiently.
The appliance makes a lot of noise.
Error code E0
Error code E2
7

technical specifications

Type number
Voltage
Connected load
Cooling capacity*
EE Class*
EER*
Power consumption kW
Power consumption Standby W
Current consumption nom. A
Air displacement max. m
3
Dehumidification max. ** L/24h
Suitable for m
3
Refrigerant / GWP type/gr
Thermostat range °C
Fan speeds
Max. noise level dB(A)
Dimensions (hxwxd)
Nett weight
Protection class
Remote control
Possible cause
The indicator light on the water tank
flashes and the water tank is full.
The room temperature is lower than
the set temperature.
Not all doors and windows are closed.
There are heat sources that are
active in the room.
The temperature is set too high.
The air inlet is blocked.
The surface on which the appliance is
placed is not level of flat enough.
The noise is caused by the flowing
refrigerant liquid within the air
conditioner.
The sensor of the room temperature
is defective.
The water tank is full.
/h
Solution
Empty the water tank.
Set the temperature once more.
Make sure that all doors and windows
are closed.
Remove the heat sources or switch
them off if possible.
Set the temperature once more.
Clean the air inlet grille.
Place the appliance on a flat surface,
level if possible.
This is normal.
Have the sensor replaced (the
appliance is also able to function
without replacing the sensor).
Empty the water tank.
AC901
220-240Volt ~50Hz
1000 Watt
9000Btu/h (2.6kW)
A
2.6
1.00
0.5
2.6 kW
320
28
80
R-290 / 3 /160 g.
16 - 31
2
65 dB(A)
680 x 330 x 280 mm
19.0 kg
IP 20
yes
23
English •