Before Using For The First Time - Inventum AC902B Mode D'emploi

3

before using for the first time

Follow these instructions when using the appliance for the first time: Carefully unpack the air conditioner and all accessories
and remove all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of reach of children.
After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient ventilation.
Check that all mentioned accessories have been supplied.
Clean the air conditioner with a slightly damp cloth.
Prior to connecting the appliance, check that:
• the connection voltage corresponds with what is stated on the information plate;
• the socket and cord are suitable for the appliance;
• the plug of the cord fits in the socket;
• the appliance is placed on a stable and flat surface.
PLACEMENT OF THE AIR CONDITIONER
A mobile air conditioner must be placed on a flat surface with sufficient room all around. Do not block the air outlet and
ensure a free space of minimum 50 cm around the air conditioner.
After placing the appliance in a straight position, allow it to stand for at least 2 hours before inserting the plug in the socket.
INSTALLING THE AIR DISCHARGE HOSE
Place the appliance near a window or opening, so that the air can flow to the outside via the discharge hose.
1. Carefully pull out the discharge hose until the required length is achieved.
2. Screw an end of the discharge hose [ a ] in the square connector [ b ].
3. Screw the round connector [ c ] on the other end of the discharge hose.
4. Slide the square connector [ b ] at the rear of the air conditioner on the air outlet [ d ].
5. Hang the other end of the discharge hose to the outside. Ensure a free passage of the hose. Close the window and door
as much as possible. If necessary, use the window seal set.
b a
REMARK: Optimum operation of the air conditioner depends on the length of the discharge hose and the number of
bends. Try to limit both. The supplied flexible discharge hose has a maximum length of approx. 150 cm and corresponds
with the capacity of the air conditioner. The use of any other hoses or extensions could cause failures in the appliance.
The air should be able to flow without any hindrance, or else this could cause overheating of the appliance or
condensation of water in the air discharge hose. Therefore make sure there are no kinks or sharp bends in the discharge
hose. For an optimum result, the discharge hose should be kept shorter than 1 metre during use of the air conditioner.
24
• English
c
d b