Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
control and the receiver).
•
The remote control must be handled with extreme care.
Do not drop it or expose it to direct sunlight or sources of
heat.
DESCRIPTION OF THE REMOTE CONTROL
19) "ON/OFF" button
20) Increase/Decrease button for temperature/programmed
use
21) "MODE" button
22) "TIMER" button
23) °F/°C scale button
24) Fan speed selection button (MAX/MED/MIN).
19
24
23
Inserting or replacing the batteries
•
Remove the cover on the rear of the remote control;
•
Remove the old batteries, if present.
•
Correctly insert two new L03 "AAA" 1,5V batteries (see the
instructions inside the battery compartment);
•
Replace the cover.
If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in
accordance with current legislation as they are
harmful to the environment. Do not mix old and new
batteries. Do not mix alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries. Do not
dispose of batteries in fire. Batteries may explode or
leak. If the remote control will not be used for a certain
length of time, remove the batteries.
Using the remote control unit
•
•
20
21
22
•
•
TURNING THE APPLIANCE ON
Plug the appliance into the the electrical receptacle.
Press the ON/OFF button (19) (when turned on, the air
conditioner starts operating in the same mode as when it was
turned off).
Press the MODE button (21) to select the required mode
COOLING
DEHUMIDIFYING
FAN ONLY
On the control panel, the light corresponding to the selected
mode comes on.
For air conditioning/dehumidifying/fan only settings and
programming the timer, see page 8.
9
Note: This e quipment h as b een t ested a nd f ound t o c omply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help. Changes or modifications not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian CAN
ICES-3 (B) / NMB-3 (B).
en
Publicité
Table des Matières
