DeLonghi PAC N Série Mode D'emploi page 6

French window
• After having screwed the window outlet 17 into the air
exhaust hose 12 , open the French window slightly and
position the window outlet 17 as shown in figure E.
E
SEMI-PERMANENT INSTALLATION
If required, your appliance can also be installed semi-
permanently (Fig. F).
F
Proceed as follows:
• Drill a hole (ø134mm / 5.27 in.) in an outside wall or
through a window pane.
Respect the height and dimensions of the hole given in
figures F and G.
NOTE: As special tools are required for installation, we suggest
you have the appliance installed by specialized personnel.
KEEP THE AIR HOSES AS SHORT AND FREE OF CURVES AS
POSSIBLE TO AVOID CONSTRICTIONS.
Preparing for use
in the window pane in the wooden
kickboard of a
French window
G
• Fit the wall flange 11 into the hole.
Screw the hose adaptor 13 to the hose's end 12.
•
• Fit the air exhaust hose in the housing at the back of the
appliance as shown in figure A.
• Screw the wall mounting accessory 14 into the hose 12
(fig. H) and fit it into the wall flange 11 as shown in fig. I.
H
I
When the hose 12 is not fitted, the hole can be closed with the
flange cap 11 .
NOTE: When installing the air conditioner semi-permanently,
you should leave a door slightly open (as little as 1/2" (1 cm))
to guarantee correct ventilation.
6
en
in the wall: you are
recommended to
insulate the section
of wall using suitable
insulation.
2
MAX 39 inches
MAX100 cm
MAX 14 inches
MIN 35 cm