QUNDiS RNG5 Notice D'utilisation Et D'installation page 27

Mounting point requirements:
The GSM/UMTS signal strength can be determined at the gateway via the control menu, using the
appears on the display. Move the Q gateway 5 to a location with a better GSM/UMTS signal and repeat the process.
Ensure an adequate radio link is available to a RNN5 of the Q AMR network to be read out.
the building and repeat the procedure.
menu using the Scan
The minimum distance between the Q gateway 5 and a Q AMR network node should be 3 metres.
The following tools are necessary for correct mounting:
•
• Cross-slot screwdriver or cordless screwdriver
•
• In addition for Q gateway 5 RNG5N00R1x:
Before wall mounting
RNG5N00R1x only
6
RNG5N00R1x only
14
6
• Open the housing cover.
•
power supply board with the plug
14
the main board using the enclosed
mains connection cable.
V2.1 / 14.03.2019
Operating and Installation Instructions Q gateway 5 - EN
• Open the housing cover.
• Plug the battery connector into the power supply connector
ted. The green LED
• Close the battery compartment
• Insert the enclosed hexagon nut
the inside in
the
To do this, push the nut into the guide
6 on
FUM5-00AM-DES-G5021
5
7
.
•
the outside through the through-hole
. on the
Q SMP
6 .
-
.
27