Milwaukee 8936-20 Manuel De L'utilisateur page 3

SPECIFICATIONS
Volts
Cat. No. AC Amps For Materials
8936-20 120 12* Wet or Dry
8938-20 120 7.4 Wet or Dry
8950 120 8 Wet or Dry
8955 120 8 Wet or Dry
* For Cat. No. 8936-20 with onboard outlet: The entire unit is rated at 12 amps. The vacuum motor is rated at 9.5 amps.
The outlet on the motor head is rated at 8 amps.
FUNCTIONAL DESCRIPTION
1. Handle
2. Exhaust port
2
3. Tank latch
3
4. Intake port
5. Tank
4
6. Utility Outlet
(Cat. No. 8936-20 only)
6
5
SYMBOLOGY
Hertz
Amps
Underwriters Laboratories, Inc.
United States and Canada
Tank Capacity Air Flow
Gallons Cubic Feet per Minute
7.5 190
9 100
8 143
10 143
1
1
2
4
5
4
Sealed Suction
WARNING
in Water
the risk of injury, always unplug tool before
60"
changing or removing accessories. Only use
80"
accessories specifi cally recommended for
45"
this tool. Others may be hazardous.
45"
Assembling Dolly (Cat. No. 8955)
Assemble as shown in the diagram. You will need
a hammer and a phillips screwdriver.
Fig. 1
3
1. Place wheels on rear frame (B) by tapping in the
axle (C), fi tting the wheel (D) on the axle and
tapping a cap nut (E) on with a hammer.
2. Align front frame (F) and rear frame (B) so that
they fi t together and fi t lip of tank (H) into the
grooves in front and rear frames.
3. Secure frame (B and F) to the tank by placing
the hex bolts (I) through the holes in dolly and
securing them with nut (L) and washer (K) as
shown.
4. Insert caster (G) and push down until caster
snaps into place.
ASSEMBLY
Installing Handle (Cat. No. 8955)
You will need either a fl at blade screwdriver or a
To reduce
socket driver and a wrench or a pair of pliers.
Fig. 2
A
1. Place dolly handle between tank and side handle
B
on either side of the tank.
2. Fasten tightly with slotted hex head screws.
Assembling Dolly (Cat. No. 8938-20)
Assemble as shown in the diagram. You will need:
(2) 1/2 inch open end wrenches, (2) 7/16 inch open
end wrenches, or a socket set and a hammer.
F
C
Fig. 3
E
G
D
H
I
J
K
L
1. Insert 2-1/2 inch long bolt through the center hole
in rear frame, attach split lockwasher, and nuts.
Tighten securely.
2. Attach handle brace to back of rear frame with
5/8 inch long machine screws, lockwashers, and
nuts (Finger tight only).
3. Position main frame inside rear frame. Attach
with (2) 5/8 inch long machine screws, lockwash-
ers and nuts in both sides. Tighten securely.
5