Inserting Or Replacing The Batteries; Turning The Appliance On - DeLonghi AN125HPEK Mode D'emploi

DESCRIPTION OF THE REMOTE CONTROL FIG. D
D1) ON/STAND-BY button
D2) Increase/decrease temperature/programmed operation
D3) " MODE" selection button
D4) Fan speed selection button
D5) Switch button °C/°F
D6) TIMER button
D
D1
D2
D4
D5

INSERTING OR REPLACING THE BATTERIES

• Remove the cover on the rear of the remote control;
• Replace the old batteries with two new R03 " AAA" 1.5V bat-
teries, inserting them correctly (see the instructions inside
the battery compartment);
• Replace the cover.
If the remote control unit is replaced or discarded, the batter-
ies must be removed and disposed of in accordance with cur-
rent legislation as they are harmful to the environment. Do not
mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in re.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.

TURNING THE APPLIANCE ON

• Plug into the electrical receptacle.
• Press the button (D1) (when turned on, the air con-
ditioner starts operating in the same mode as when it was
turned o ) .
• To switch the appliance o , press button
remove the plug.
NOTE: Never switch the appliance o by removing the plug.
Always switch it o by pushing on the
waiting few minutes before removing the plug. Only in this
way the appliance will perform the standard chec ings.
FUNCTIONS SELECTION
The controls on the remote control are the same as those on the
control panel of the appliance (C). You should therefore refer to
the instructions in the chapter "OPERATING FROM THE CON
TROL PANEL" to select the desired functions. Press button D5
to switch the temperature display from °C to °F and vice versa.
Note:
•
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residen-
tial installation.
• This equipment generates, uses and can radiate radio fre-
D2
quency energy and, if not installed and used in accordance
D3
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
D6
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit di er-
- Consult the dealer or an experienced radio/TV technician
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's au-
thority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
• This Class B digital apparatus complies with Canadian CAN
ICES-3 (B) / NMB-3 (B).
(D1), then
button and
10
receiver.
ent from that to which the receiver is connected.
for help.