iRoom iO83 Mode D'emploi page 5

MANUAL
Page 5
iO83 Relais Card
Wi-Fi integration
Step 6 In the "Work Mode" settings, check "STA mode" and "LAN Mode", then press
"Save". Press "Back" in the next confirmation window to stay in the settings menu!
Step 6.1 In the "STA Settings", you can connect to your local Wi-Fi network. Press
"Scan" to find your network, then select your desired network and confirm with "ok".
Step 6.2 Now you should be able to see your network. Enter your "Password" and
press "Save". If you want the card to retrieve an IP address automatically through
DHCP(not recommended due an automatic change of the IP router in Restart),
press "Restart" to complete the configuration. If you want to use a static IP address
(recommended), then press "Back" and follow the next steps.
Step 6.3 To set a static IP address, disable "Obtain an IP address automatically" in the
"STA Settings". Enter your desired IP addresses, click "Save" - "Restart"
LAN integration
Step 7 In the "Work Mode" settings, check "STA mode" and "LAN Mode", then press
"Save". Press "Back" in the next confirmation window to stay in the settings menu!
Step 7.1 In the "AP Settings" enter your desired static "IP address" and disable
"DHCP Server", press "Save"
Step 7.2 Re-start the relay card by pressing "Restart".
Step 7.3 Once the green "Ready" LED lights up, plug in the network cable.
DO NOT DO THIS BEFORE!
Step 7.4 Disconnect the power cord for 10 seconds and plug it in again,
to complete the configuration.