Bartscher 700207G Mode D'emploi page 27

•
To avoid damage to the compressor, when setting up or transporting the device do
not tilt it to a degree in excess of 45º.
•
Do not place the device near sources of open flame, electric ovens, electric heaters
or other heat sources such as direct sunlight. High temperatures may damage the
device's surface and have a negative impact on cooling efficiency and energy use.
•
Locate the device so that sufficient air circulation is ensured. Keep a distance of at
least 10 cm at the sides and rear from walls and other objects. Leave sufficient
space at the front for personnel.
•
Never cover the device's ventilation ducts.
•
Never place the device in locations with high ambient humidity. Too much moisture
may damage the device.
•
Do not drill any holes or mount any objects on or in the device.
•
Do not place any heavy objects on the device.
Connecting the device
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
If the device has not been transported in a vertical position, wait at least 2 hours for
the coolant to settle before connecting it to a power source.
•
In the event of a power outage or if the device is unplugged, do not reconnect
the device to the power network for at least 5 minutes.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
- 26 -