Technical Data - CONSTRUCTOR CTPS1400-140 Traduction Des Instructions D'origine

CLEANIG AND MAINTENANCE
performing any work on
the equipment, pull the
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Carbon Brush Replacement
• Remove and check the carbon brushes regularly.
• Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
• Use a screwdriver to remove the brush holder
caps.
• Take out the worn carbon brushes, insert the
new ones and secure the brush holder caps

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
Speed
Min. speed rating saw blade
Saw blade diameter
Max. saw blade thickness
Min. tooth thickness
Blade bore
Max. depth of cut
Mitre angle
Weight
Noise emission values measured according to
relevant standard.
Acoustic pressure level
L 92 dB(A) K = 3 dB(A)
PA
Acoustic power level
L 103 dB(A) K = 3 dB(A)
WA
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. :
a = 4.0 m/s ² K = 1,5 m/s ²
h
Attention! Before
power plug.
230 V
50 Hz
1400 W
2200-5200 min
7000 min -1
190 mm
1.5 mm
2.6 mm
20 mm
65 mm
0-45°
7.2 Kg
ATTENTION !
must be worn.
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
CONSTRUCTOR application service team will
gladly answer questions concerning our products
and their accessories :
STORAGE
-1
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Made in China
sav@eco-repa.com
Should your machine need
replacement after
extended use, do not put it
in the domestic waste but
dispose of it in an
environmentally safe way.
2021
27