Jacuzzi nova pure air Manuel D'installation Et D'utilisation page 25

Blower
Fill the tub with the water required for normal bathing.
Turn on the main switch and wait a few seconds until the start-up
process has completed.
NOTE: check that there are no objects resting on the control pan-
el (located above the tub edge).
To activate the hydromassage, press the
edge); repeat to disable this function.
NOTE: the hydromassage will turn itself off automatically after 20 min-
utes.
We recommend leaving the hydromassage active for a duration
of 15-20 minutes (5-10 minutes are necessary before the action of
the moving water begins to take effect).
We recommend setting the water temperature at approximately
36 °C; in the instance of higher temperatures, it is advisable to re-
duce the duration of the hydromassage:
34-36 °C --> 20 minutes of hydromassage
36-38 °C --> 15 minutes of hydromassage
38-40 °C --> 10 minutes of hydromassage
Soap and bath foams (where not used as part of hydromassage)
must only be used when the hydromassage is not in use.
Draining the blower circuit: Approximately 5 minutes after the
tub has been emptied (that is, from when the level sensor no longer shows that there
is water in the tub), the blower is activated automatically for approxi-
mately 30 seconds. This is to remove any remaining water (which
may have entered when draining the tub) from the pipes connected
to the nozzles on the bottom of the tub.
It can be activated manually if you should so wish:
- wait for the tub to empty fully.
- tap the button
seconds, after which you can switch off the main power supply
switch for the tub.
Light
To switch on the light, press the
the tub edge).
To switch it off, press down the button until the light goes out.
button (on the tub
It is possible to have either a white or coloured light; a light which
changes colour assuming different sequences is also available.
The colour sequences are as follows:
- Cromodream (based on a mixed colour sequence);
- Relax (based on a blue colour sequence);
- Energy (based on a red colour sequence).
NOTE: each sequence begins gradually then, after a few seconds,
reaches its characteristic intensity.
The individual colours:
- white;
- turquoise;
- green;
- orange;
- violet.
Where the water level in the tub is below that required for hydro-
massage, the light will function at reduced power.
IT IS also possible to turn on the light when the tub is empty, using
it as a courtesy light (the light will function at reduced power in this
context too).
After using the tub, wait for the blower to drain fully (see the rel-
evant chapter) then switch off the main power supply to the tub.
25
with your finger to activate the blower for 30
button for a few seconds (on