Siemens TI3 1 Série Mode D'emploi page 48

en Trouble shooting
' LED lit up despite water
tank being full.
' LED flashes and all bever-
age LEDs flashing.
All LEDs flashing.
', ( and calc'nClean LEDs
flashing.
( and % LEDs flashing. Brewing unit very heavily soiled
% LEDs flashing.
calc'nClean and ) light up.
Display "calc'nClean" keeps on
appearing.
If you are unable to solve the problem, always call the hotline.
You will find the telephone numbers at the back of these instructions
--------
48
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Water tank is missing or not
inserted correctly.
The pipe system in the appli-
ance is dry.
Air in the water filter.
Incorrect voltage in building.
The ambient temperature is too
cold.
or brewing unit cannot be
removed.
Fault in the appliance.
The descaling process has
been interrupted.
The water is too hard.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 38
Insert a new water filter.
Insert water tank correctly.
Insert water tank correctly.
Fill the water tank with fresh tap water.
Do not fill with carbonated water.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 38
Operate the appliance at 220V-240V
only.
Operate the appliance at temperatures
> 5 °C.
Clean brewing unit if possible and
switch appliance off and back on
again.
Restart appliance.
Continue the descaling process.
~ "Service programme" on page 44
Insert water filter and set water hard-
ness accordingly.