Removing The Filter - Jackson Airmax Instructions D'utilisation

FILTER REPLACEMENT CRITERIA
Filter should be replaced in all cases when its integrity is suspected to have been affected as a result of contamination or physical
damage.
Filter must also be replaced at the end of its service lifetime, which can be determined when the fully charged operational JACKSON
SAFETY AIRMAX PAPR unit can't supply airflow above 170LPM tested with the use of the Flow-Test-Unit provided with the product.
® ®
This is clear indication that the filter is clogged and should be replaced.
If the alarm deactivates after replacing the filter, the unit is fully operational again; if not, recharge the unit before using it in a contaminated
area. You should always double check the air flow again with the Flow-Test-Unit to make sure the unit is fully operational.

REMOVING THE FILTER

Push the filter-housing down towards the body of the blower unit and apply a twisting force in a clock-wise direction to pull the filter away
from the unit.
FITTING THE FILTERS
Inspect the filter sealing gasket filter panels and confirm that is free of damage. Make sure that the new filters are used within their expiry
date. Make use of the opportunity to inspect that the filter holder is clean; finally assemble the new filter into the blower.
Place the filter over the corresponding circular recess in the blower unit. Twist lightly until the 4 location lugs, fall into the corresponding
recesses. Force the filter down towards the blower unit and apply a twisting force in an anti-clockwise direction until the 4-way bayonet
system is heard locking into place.
WARNING!
It is essential that the user must not confuse the markings on the filter relating to any other
standard other than EN12941:1998 + A1:2003 + A2:2008 with the classification of the device
when used with this filter.
The filters must be regularly checked (see Air Flow Test) and replaced. Filters are intended to
be replaced and not cleaned / re-used.
8