Battery Installation/Removal - StreamLight TLR-7 Série Instructions D'utilisation

FLASHLIGHT MOUNTING/REMOVAL
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN. IT IS IMPERATIVE
THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES WHILE HANDLING THE FIREARM.
1. The TLR is designed to be quickly attached or detached from the side of the weapon or
accessory rail.
2. Loosen the rail clamp tension bolt.
3. Angle the TLR, placing the fixed portion of the rail clamp against the accessory rail and
align the rail key with the appropriate cross groove in the accessory rail.
4. Depress the rail clamp tension bolt to open the rail clamp, rotate the TLR into place and
release the pressure on the tension bolt to "snap" the light in place.
5. Check for fit and tighten rail clamp tension bolt until the TLR is securely attached to the firearm.
NOTE: A coin should be used to obtain sufficient tightness. Tighten only "finger tight".

BATTERY INSTALLATION/REMOVAL

FOR SAFETY PURPOSES THE TLR MUST BE REMOVED FROM THE FIREARM BEFORE
THE BATTERY COMPARTMENT IS OPENED OR CLOSED.
At the end of battery life, the switch may appear intermittent or non-functional.
Replacing the battery will restore normal operation.
1. Unscrew and remove the facecap assembly from the body of the TLR.
Remove the exhausted battery from the flashlight body.
2. Insert a fresh CR123A battery, positive end first, into the body of the TLR.
Battery polarity is indicated on the side of the TLR body.
3. Place the facecap assembly onto the TLR body. Fully tighten the facecap assembly to ensure
that the battery makes complete contact with the internal electrical contacts.
4. For "safe" mode, loosen the facecap approximately ¼ turn to the detent. The light/laser
will not turn on when either button is pressed and the battery is disconnected.
Safe mode