Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
x
Operation, Parameters
The integrated Booster Heater (BOH) is also controlled in a fully-
automatic manner by the controller integrated in the DAIKIN
EKHHP. The switching limits and switching time periods are de-
fined in the parameter settings. If the Booster Heater (BOH) is
switched on, in the display of the controller, the icon
If the DAIKIN EKHHP is in an "OFF" period, the tariff
contact HT/LT and SG can no longer be evaluated and
thus have no influence on the operation of the instal-
lation.
5.4.1 Display switching times
1. Press the
key.
The current operating mode flashes.
2. Use the
and
keys to select the operating mode to be
programmed.
The selected operating mode flashes.
3. Use the
key to confirm the selection.
The first weekday "MON" is displayed.
4. Use the
and
be programmed.
5. Use the
key to confirm the selection.
The first switching time programmed for the selected
operating mode is displayed.
6. Use the
and
switching times for this operating mode. Empty switching
times are not displayed.
This key
moves you back by one step.
5.4.2 Programming switching times
7. Hold the
key pressed for 5 s.
8. Use the
key to select the switching time number.
9. Use the
and
10. By pressing the
key, you can select the type of
switching
for this switching time number.
11. Confirm the switching time and switching type using the
key (press briefly).
12. Repeat steps 8 to 11 to program the other switching times or
to change to the highest switching time of the current day
(see step 6). Then continue with step 13 to complete
programming.
13. Hold the
key pressed for 5 s.
The switching time set is displayed, saved and all switch-
ing times below that are also saved. All switching times
above the current switching time are deleted.
It automatically returns to step 6.
Installation and maintenance manual
22
appears.
keys to select the weekday to
keys to move to the other
keys to set the starting time.
Fig. 5-2
Display and programme switching times
5.4.3 Delete switching time
Delete individual switching times
Deleting one or more programmed switching times is carried out
at the same time as saving the programmed switching times.
The following table explains the procedure.
For example:
– At least 4 switching times were programmed for Monday.
– Switching times 1 to 3 are set.
– After the third switching time, the key
confirms the end of the programming.
– The fourth switching time and, if there is one, the fifth switch-
ing time will be deleted.
(hold for 5 secs.)
DAIKIN EKHHP(3/5)00AA2V3
DAIKIN Hot water heat pump
008.1423444_02 – 09/2015
Publicité
Chapitres
Table des Matières
