How To Install The Unit - LG LW1014CR Guide D'utilisation

Installation

How to Install the Unit

1. To prevent vibration and noise, make sure the
unit is installed securely and firmly
2. Install the unit where the sunlight does not
shine directly on the unit.
3. The outside of the cabinet must extend outward
for at least 14" and there should be no
obstacles, such as a fence or wall, within 20"
from the back of the cabinet because it will
prevent heat radiation of the condenser.
Restriction of outside air will greatly reduce the
cooling efficiency of the air conditioner.
NOTICE
All side louvers of the cabinet must remain exposed to the outside of the structure.
4. Install the unit at a slight incline so the back is slightly lower than the front(about 1/4").
This will force condensed water to flow to the outside.
5. Install the unit with the bottom about 30"~60" above the floor level.
Horizontal Sliding Window Installation
1. Loosely attach the Suppor t Bracket to the
bottom of Bracket using Bolts, Washer, and
Nuts. Attach the Leveling Bolt and Nut. (Fig. 1)
2. Remove protective backing from Window
Track Seal and apply seal to windo w track.
(Fig.2)
3. Measure and lightly mark a line 8 1/4"
from window jamb. Center the Support
Bracket assembly on the window track and
fasten with 4 Type C screws.(Fig. 2)
12 Room Air Conditioner
Cooled air
Washer
Nut
Support Bracket
Window Jamb Window Jamb
1 /
4
Window Track Window Track
Seal Seal
Window Track Window Track
Awning
Fence
Heat
radiation
About
1/4" (6.4mm)
Over
20" (508mm)
Bolt
Bracket
Leveling Bolt & Nut
Fig. 1
Type C screw Type C screw
Fig. 2