Publicité
Les langues disponibles
Les langues disponibles
Changing the Diamond Cutting Discs
Attention!
The Cutting discs, spacer discs and the flange nut might heat up
enormously during operation. You could burn your hands or get cut or
ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
Fig.3
Fig.4
Pre-selection of the Groove Width :
•
The groove width results from the number and thickness of the spacer discs
between the two diamond cutting discs and the cutting width of the diamond
cutting discs.
The grove width is calculated as follows: groove width = Thickness of the
spacer discs + width of the diamond cutting discs.
Thickness of the spacer discs: 2, 3, 4, 6 and 10 mm
Press the spindle lock button to lock the work
spindle .
Actuate the spindle lock button only when
the work spindle is at a standstill.
Otherwise,
the
machine
damaged.
Open the clamping screw with the face spanner
and remove the diamond cutting discs as well as
the spacer discs from the work spindle
Clean the work spindle and all parts to be
mounted.
22
may
become
.
Publicité
