Depth Gauge - Makita DHR400 Manuel D'instruction

To remove the drill bit, pull the chuck cover down all the
way and pull the drill bit out.
1
► 1 . Drill bit 2. Chuck cover
Chisel angle (when chipping,
scaling or demolishing)
The chisel can be secured at the desired angle. To
change the chisel angle, rotate the action mode chang-
ing knob to the O symbol. Turn the chisel to the desired
angle.
► 1 . Action mode changing knob 2. Pointer
Rotate the action mode changing knob to the
bol. Then make sure that the chisel is securely held in
place by turning it slightly.

Depth gauge

The depth gauge is convenient for drilling holes of
uniform depth.
Press and hold the lock button, and then insert the
depth gauge into the hex hole.
2
► 1 . Depth gauge 2. Lock button
Make sure that the toothed side of the depth gauge
faces the marking.
1 2
► 1 . Marking 2. Toothed side
Adjust the depth gauge by moving it back and forth
while pressing the lock button. After the adjustment,
release the lock button to lock the depth gauge.
NOTE: Make sure that the depth gauge does not
touch the main body of the tool when attaching it.
sym-
10 ENGLISH
1 2
1 2