Installing The Tv To The Wall - Sony Bravia KDL-50W800B Mode D'emploi

Masquer les pouces Voir aussi pour Bravia KDL-50W800B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing the TV to the Wall

To Customers
Sufficient expertise is required for installing this product. Be sure to subcontract the
installation to Sony dealers or licensed contractors and pay special attention to safety during
the installation. Sony is not liable for any damages or injury caused by mishandling or
improper installation, or installing any other than the specified product. Your Statutory Rights
(if any) are not affected.
To Sony Dealers and Contractors
Sufficient expertise is required for installing this product. Be sure to read this instruction
manual thoroughly to do the installation work safely. Sony is not liable for any damages or
injury caused by mishandling or improper installation.
Your TV's Table-Top Stand will be used as a part of the Wall-Mount Bracket.
Your TV can be mounted on a wall using a Wall-Mount Bracket (supplied with the TV) out of the
box as packaged. If the Table-Top Stand is attached to the TV, the TV may require detaching
the Table-Top Stand; see page 11 (Detaching the Table-Top Stand from the TV).
Prepare the TV for the Wall-Mount Bracket before making cable connections.
For product protection and safety reasons, Sony strongly recommends that you use the
Wall-Mount Bracket (supplied with the TV) designed for your TV and the installation
should be performed by a Sony dealer or licensed contractor.
• Follow the instructions provided in this manual for installing the Wall-Mount Bracket.
Sufficient expertise is required in installing this TV, especially to determine the strength of
the wall for withstanding the TV's weight.
• Be sure to use the screws supplied with the Wall-Mount Bracket when attaching the
Mounting Hook (Stand) to the TV set.
The supplied screws are designed as indicated by illustration when measured from the
attaching surface of the Mounting Hook (Stand).
The diameter and length of the screws differ depending on the Wall-Mount Bracket model.
Use of screws other than those supplied may result in internal damage to the TV set or
cause it to fall, etc.
7 mm
Screw
(supplied with the
Wall-Mount Bracket)
Mounting Hook (Stand)
Hook attachment on rear of
TV set
• Be sure to store the unused screws and Stand Necks in a safe place until you are ready to
attach the Table-Top Stand. Keep the screws away from small children.
~
• Read the supplied Safety Booklet for additional safety information.
(Continued)
33
US
US

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Bravia kdl-50w790bBravia kdl-42w700bBravia kdl-32w700b

Table des Matières