Dymo XTL 300 Guide De Démarrage Rapide page 5

Inserting the Label Cartridge
Your label maker uses DYMO XTL
widths and materials including continuous tape and pre-sized labels. Visit
www.dymo.com for information about purchasing label cartridges.
Press the button on the top of the label
1
maker and lift the label compartment
cover. See Figure 2.
Make sure the tape and ribbon are taut
2
across the mouth of the label cartridge
and that the tape passes between the
label guides. See Figure 3.
To tighten the ribbon, turn the ribbon
rewind spool in the direction indicated
by the arrow on the cartridge.
Do not touch the electronic chip on the
side of the label cartridge.
Insert the label cartridge and press
3
firmly until the cartridge 'clicks' into
place.
4
Close the label compartment cover.
TM label cartridges, available in a variety of
Ribbon
rewind
Do not
touch!
Press
and lift
Figure 2
Label
guides
Figure 3
3