Adjusting The Arm Support; Adjusting The Stability And The Maneuverability - Vermeiren V300 XL Mode D'emploi

3.7

Adjusting the arm support

The arm support of your wheelchair can be adjustable in height and depth. The height of the
arm support can be adjusted in 3 positions.
Height armsupport to seat Number of the blocks
220 mm (Standard)
230 mm
240 mm
The depth of the armrest can be adjusted in 3 positions.
Depth of the armrest
Front position
Middle position (Standard)
Back position
Adjust the height and the depth of the armrest as follow:
1. Remove both screws under the armrest.
2. Place the correct number of blocks under and above the tubes, see table 4.
3. Install the armrest with the required holes for depth adjustment.
3.8

Adjusting the stability and the maneuverability

The stability and maneuverability can be adjusted by moving the axle plate of the rear
wheels d.
under the tube
2
1
0
Table 4: Height of arm support
Back and middle
Front and middle
Table 5: Depth of armrest
Adjust the stability and maneuverability according
following steps:
1. Loosen the bolts of axle plate.
2. Move the axle plate d in the desired position.
3. Retighten the bolts.
ƒ‰‡
Number of blocks between
tube and armrests
1
2
3
Used holes
Hole 2 and 4
V300 XL
2012-02