Belt Replacement - DeWalt DXCMLA3706056 Guide D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

wise) on bottom of tank.

WARNING: Risk of bursting. Water will condense in the air

tank. If not drained, water will corrode and weaken the air tank

causing a risk of air tank rupture.

NOTICE: Risk of property damage. Drain water from air tank may

contain oil and rust which can cause stains.

After the water has been drained, close the drain valve (clock-

wise). The air compressor can now be stored.

NOTE: If drain valve is plugged, release all air pressure. The valve

can then be removed, cleaned, then reinstalled.

Compressor Pump Oil (Fig. 4)

NOTICE:

Risk of property damage. Use air compressor oil only.

Multi-weight automotive engine oils like 10W30 should not be used

in air compressors. They leave carbon deposits on critical compo-

nents, thus reducing performance and compressor life.

NOTE: Use full synthetic, non-detergent air compressor oil.

NOTE: Crankcase oil capacity is approximately 16 fluid ounces

(473,2 ml).

Checking

The oil level should be to the middle of the sight glass (K).

If needed remove oil fill plug (G) and slowly add oil until it

reaches the middle of the sight glass.

Changing

WARNING: Drain tank to release air pressure before removing

the oil fill cap or oil drain plug.

Remove the oil fill plug (G).

Remove the oil drain plug (H) and drain oil into a suitable con-

tainer.

Replace the oil drain plug (H) and tighten securely

Slowly add compressor oil until it reaches the middle of the

sight glass (K). NOTE: When filling the crankcase, the oil

flows very slowly into the pump. If the oil is added too quickly,

it will overflow and appear to be full.

CAUTION: Overfilling with oil will cause premature compressor

failure. Do not overfill.

Replace oil fill plug (G) and tighten securely.

L = Full

M = Add

H = Oil drain plug

K = Oil level sight glass

G = Oil fill plug