GE Profile DPVH890GJ0WW Manuel D'utilisation Et D'installation page 44

INSTALLING THE PEDESTAL (if desired) (cont.)
LEVEL THE WASHER OR DRYER
4
A Stand the washer or dryer upright. Move it
close to its final location.
B Make sure that the washer or dryer is level
by placing a level on top. Check side to side
and front to back.
Use an open
C
ended wrench
to adjust the
legs in and out.
Tighten the lock
nut against
the bottom
of the pedestal.
NOTE: To minimize vibration, the locking nuts
must be tight.
REINSTALL THE DRAWER
5
Check to
A
be sure the
slides are
closed.
Slide the
B
drawer
Drawer
into the
Divider
opening.
Align the
drawer
supports to the
slides on each
side.
Reinstall the original screws into each drawer
C
slide. Tighten both screws.
D Open the drawer fully. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
Installation Instructions
44
REMOVE SHIPPING SCREWS
6
Remove the 4 shipping screws on the back side
of the washer.
FINALIZE THE INSTALLATION
7
Refer to the washer or dryer Installation Instructions
to complete the installation.