Festo SLTE-10 Série Notice D'utilisation page 31

SLTE
Reference travel against a reference switch:
S
Make sure that both rubber buffers are
situated as end position cushioning in the
fixed stops 6 (status as at delivery).
If necessary, press one of the rubber buf­
fers supplied into the empty holes of each
of the fixed stops.
With all applications:
S
Make sure that the device is fitted free of
mechanical stress and distortion.
S Make sure that drive module 4 has
sufficient space for heat dissipation.
Narrow installation situations can cause
an accumulation of heat.
S
Avoid damaging the slide guide.
Damage to the slide guide will impair the functioning of the roller bearings.
Festo SLTE 1505b English
Fig. 3
Fig. 4
31