Listening To A Cassette Tape - Teac W-1200 Mode D'emploi

This unit can play normal (type I), chrome (type II) and metal (type IV)
tapes.
Press the POWER button to turn the unit on.
1
2 Press the EJECT (-) button to open the cas-
sette compartment.
3 Load a cassette tape into the compartment.
Insert the cassette tape with the playback side facing forward
and its open edge facing down. Then, close the cassette com-
partment by pushing it gently. Use caution, because forcing it
shut could cause malfunction.

Listening to a cassette tape

4
ATTENTION
Never turn the power off or disconnect the power cord during
playback. Doing so could cause the tape to become stuck, for
example.
Notes about playing (recording) a tape in one deck when
tapes are loaded in both cassette holders
If the play (y) button is pressed for the tape that is not playing
(recording)
e The tape that is playing (recording) will stop, and the tape for
If the record (0) button is pressed for the tape that is not playing
(recording)
e The tape that is playing (recording) will stop, and the tape for
If a rewind/fast-forward (m/,) button is pressed for the tape
that is not playing (recording)
e The tape that is playing (recording) continues as is, and the
ATTENTION
o Confirm that the tape is not slack (page 8).
o Do not use deformed or slack tapes because they could
cause malfunction. Do not force the door of the compart-
ment by hand when opening it.
Press the play (y) button to start playback.
which the play (y) button was pressed will start playback.
(Pressing the play button prioritizes that tape.)
which the record (0) button was pressed will enter recording
standby.
tape for which the search rewind/fast-forward (m/,)
button was pressed will rewind/fast-forward.
15