Listening To A Cassette Tape - Teac TASCAM 202MKVII Mode D'emploi

This unit can play normal (type I), chrome (type II) and metal (type IV)
tapes .
1
Press the POWER button to turn the unit on.
2
Press the EJECT (-) button to open the cas-
sette compartment.
3
Load a cassette tape into the compartment.
Insert the cassette tape with the playback side facing forward
and its open edge facing down . Then, close the cassette com-
partment by pushing it gently . Use caution, because forcing it
shut could cause malfunction .

Listening to a cassette tape

4
ATTENTION
Never turn the power off or disconnect the power cord during
playback. Doing so could cause the tape to become stuck, for
example.
Notes about playing (recording) a tape in one deck when
tapes are loaded in both cassette holders
If the play (y) button is pressed for the tape that is not playing
(recording)
e When the PLAY MODE switch is set to NORMAL (page 29),
e When the PLAY MODE switch is set to SPECIAL (page 29),
If the record (0) button is pressed for the tape that is not playing
(recording)
e The tape that is playing (recording) will stop, and the tape for
If a rewind/fast-forward (m/,) button is pressed for the tape
that is not playing (recording)
e The tape that is playing (recording) continues as is, and the
ATTENTION
o Confirm that the tape is not slack (page 8) .
o Do not use deformed or slack tapes because they could
cause malfunction . Do not force the door of the compart-
ment by hand when opening it .
Press the play (y) button to start playback.
the tape that is playing (recording) will stop, and the tape for
which the play (y) button was pressed will start playback .
(Pressing the play button prioritizes that tape . )
the tape that is playing (recording) will continue, and the tape
for which the play (y) button was pressed will start monitor-
ing playback .
which the record (0) button was pressed will enter recording
standby .
tape for which the search rewind/fast-forward (m/,)
button was pressed will rewind/fast-forward .
15