Playback Modes; Automatic Power Saving Function - Teac TASCAM 202MKVII Mode D'emploi

Playback modes

Use the PLAY MODE switch to activate the special playback mode
that uses the double cassette feature .
NORMAL
This is the ordinary playback mode . Activity switches to TAPE 1 or
TAPE 2 in response to playback operation, and the playback sound is
output from the LINE OUT and the headphone connectors .
The same sound is output from the LINE OUT and the headphone
connectors .
SPECIAL
This is a special playback mode using the double cassette deck .
If one tape is playing back, recording or paused, that state will con-
tinue and its sound will be output from the LINE OUT connectors
when playback of the other tape is started . The playback sound of
the second tape will only be output from the headphones (moni-
toring playback) . Using this mode, you can cue a second tape while
playing or recording another .
To output the cued audio from the LINE OUT connectors, press the
stop (8) button to stop tape cueing .
And then, press the stop (8) button for the tape that continued
audio output from the LINE OUT connectors to stop it, and start
playback/recording of the cued tape to output its sound from the
LINE OUT connectors .
o During monitoring playback, the play (
o When monitoring playback is paused, the pause (9) indicator
blinks .
o When TAPE 1 and TAPE 2 are both stopped, they will be output
from the LINE OUT connectors when playback and recording
starts .
o Noise reduction is not applied to the sound output from the
headphone connector during monitoring playback .

Automatic power saving function

ATTENTION
The automatic power saving function is only included in
European models.
The automatic power saving function is ON when this unit is shipped
new, so it will automatically turn off if 30 minutes pass under the
conditions shown below .
 Automatic power saving function active
– Automatic power saving function not active
To reactivate the unit after it has turned off automatically, press the
POWER button on the main unit twice .
Changing the automatic power saving
setting
1
Stop both TAPE 1 and TAPE 2.
) indicator blinks .
2
Press the TAPE 1 and TAPE 2 (8) buttons at the
same time to show the current setting ("Apwr
OFF" or "Apwr On") in the tape counter area.
3
Use the TAPE 2 play (y) button to change the
setting.
4
Press the TAPE 2 stop (8) button to return to
the ordinary state.
Status Cassette tape
No cassette tape
Stopped
Recording paused


–
29