Included Items; Before Use; Beware Of Condensation - Teac TASCAM 202MKVII Mode D'emploi

Included items

Check to be sure the box contains all the included items shown
below . Please contact the store where you purchased this unit
if any of these items are missing or have been damaged during
transportation .
Remote control (RC-1331) × 1
Batteries for remote control (AA) × 2
Rackmount screw kit × 1
Owner's manual
(this document, including warranty) × 1
o Keep this manual in a safe place for future reference .
o Please see the end of the manual for information about the
warranty .

Before use

Precautions for placement and use
o The operating temperature range of this unit is 5–35 °C .
o Do not install this unit in the following types of locations .
Doing so could make the sound quality worse or cause
malfunction .
Places with significant vibrations
Near windows or other places exposed to direct sunlight
Near heaters or other extremely hot places
Extremely cold places
Places with bad ventilation or high humidity
Very dusty locations
o To enable good heat dissipation, do not place anything on top of
the unit .
o Do not place this unit on top of a power amplifier or other device
that generates heat .
o The voltage supplied to the unit should match the voltage that
is printed on the rear panel . If you are in any doubt regarding this
matter, consult an electrician .
o Do not open the cabinet as this might result in damage to the
circuitry or electrical shock . If a foreign object should get into the
unit, contact your dealer or service company .
o When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord .
V
ATTENTION
Do not turn the unit off or disconnect the power cord during
operation, including playback and recording .
Doing so could cause the tape to become stuck, for example .

Beware of condensation

Condensation could occur if the unit is moved from a cold place
to a warm place, it is used immediately after a cold room has been
heated or it is otherwise exposed to a sudden temperature change .
To prevent this, or if this occurs, let the unit sit for one or two hours
at the new room temperature before using it .
7