Repeat Playback; Recording To Cassette Tapes - Teac W-1200 Mode D'emploi

Repeat playback

You can listen to a set interval repeatedly.
1 During playback, press the REPEAT button at
the point where you want to start the repeat
playback interval.
The appears on the display.
2 Press the REPEAT button at the point where
you want to end the repeat playback interval.
The appears on the display.
The tape automatically rewinds to the starting point and play-
back starts, continuing to the ending point. When the ending
point is reached, playback stops temporarily, the tape rewinds
again to the starting point, and playback to the ending point
repeats.
Repeat playback stops automatically after 20 repetitions.
Press the stop (8) button to end repeat playback.
o During repeat playback, only the REPEAT and stop (8) but-
tons can be used.
o This function cannot be used for intervals of less than
10 counts on the tape counter between the starting and
ending points.
18

Recording to cassette tapes

Using this unit, the sound from devices connected to the line input
connectors can be recorded on cassette tapes.
This unit can record to normal (type I) and chrome (type II) tapes.
o This unit does not support recording to metal (type IV) tapes.
o This explanation describes how to record from a connected
device to TAPE 1 or TAPE 2. This unit also has functions that
allow recording a mix with sound input from a microphone
(page 21) and parallel recording to both TAPE 1 and TAPE 2 at
the same time (page 24).
1 Put a cassette tape for recording in the
compartment.
o Load it with the side to be recorded facing forward.
o If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s).
2 Press the RECORD (0) button to start record-
ing standby.
The 9 and appear on the display.
o If you want to record using the remote control, press the
two RECORD (0) buttons on the remote control at the
same time.
o Press the stop (8) button to stop recording when in record-
ing standby.