ECOFOREST HIDROCOPPER 18 Manuel D'installation Et Maintenance page 45

q
Reducing motor of endless.
w
Brass fitting and lubrication point.
5.16. To ensure the proper operation of the safety valve, it must be discharged at the end of each season or once a
year. To manipulate the valve, the rear grille should be removed from the boiler. Once you have access, turn
the thread counterclockwise until the plunger activates the discharge and return it to its initial position.
Warning: The discharge valve must be connected to a drain trap and the water passage must be visible.
q
Security valve.
IMPORTANT: After cleaning or fixing, make sure the boiler operates correctly. Once you turn the boiler off or
during the seasons when you do not use it, disconnect the stove to avoid electronic damages.
5.17. Purge the system, as explained in point 4.
5.18. Controlling the combustion air inlet and gas outlet; make sure nothing prevents normal circulation (e.g. bird
nests).
5.19. It is recommended to clean the back side of the stove that you reach through the back grids or lateral doors,
in order to take eventual dust away that might have stacked during summer time.
6. PROBLEMS AND RECOMMENDATIONS.
6.1. Do not turn the boiler on and off successively because this might damage the electronical components and
motors ~230/240V - 50Hz.
6.2. Do not touch the boiler while your hands are wet. Though the boiler is equipped with ground plug, it remains
an electric machine that could cause electric discharge if handled incorrectly. A qualified technician only shall
resolve the eventual problems.
6.3. Do not remove any screw of the zones exposed to high temperature before they have been lubricated properly
with lubrication oil.
THE BOILER REMAINS OUT OF POWER:
CHECKING AT BEGINNING OF SEASON.
WHAT NOT TO DO.
WHAT DO TO IF...
44
Drawing 25
Drawing 26