Specification; Environnemental Protection Notes - GRAUPNER 6442 Instructions D'utilisation

Battery:
Charge currents / power
Discharge currents / power
Ni-Cd & Ni-MH batteries:
Cell count
Capacity
Lithium batteries:
Cell count
Cell voltage
Capacity
Lead-acid / lead-gel batteries:
Cell count
Battery voltage
Capacity
General:
Operating voltage range DC input 11.0 to 15 V
Operating voltage range AC input 100 ~ 240V
Car battery required
Mains PSU required
No-load current drain approx
Low-voltage cut-off approx
Weight approx.
Dimensions approx. (WxDxH)
All data assumes a car battery voltage of 12.7 V.
The stated values are guidelines, and may vary according to battery state, temperature etc.
1 ) When powered by a mains PSU, the charger will only operate correctly if the PSU is suitable in terms of voltage,
stability, maximum load capacity etc. You can avoid problems by using only the PSUs which we specifically recommend.

Environnemental Protection Notes

When this product comes to the end of its useful life, you must not dispose of it in the ordinary
domestic waste. The correct method of disposal is to take it to your local collection point for
recycling electrical and electronic equipment. The symbol shown here, which may be found on
the product itself, in the operating instructions or on the packaging, indicates that this is the
case.
Individual markings indicate which materials can be recycled and re-used. You can make an
important contribution to the protection of our common environment by re-using the product,
recycling the basic materials or recycling redundant equipment in other ways.
Remove batteries from your device and dispose of them at your local collection point for
batteries.
In case of R/C models, you have to remove electronic parts like servos, receiver, or speed
controller from the product in question, and these parts must be disposed of with a
corresponding collection point for electrical scrap.
If you don't know the location of your nearest disposal centre, please enquire at your local
council office.

20. Specification

100 mA to 10.0 A / max. 120 W with internal power supply
100 mA to 10.0 A / max. 120 W with external 11...15V DC power
supply
100 mA to 5 A / max. 50 W
1 - 30 cells
min. 0.1 Ah to 10.0 Ah
1-12 cells
3.6 V (LiIo) / 3.7 V (LiPo/LiMn) / 3.3 V (LiFe)
min. 0.05 Ah to 10.0 Ah
1, 2, 3, 6, 12 cells
2, 4, 6, 12, 24 V
min. 1 Ah
12 V, min. 30 Ah
12-15V, min. 12 A stabilised
0.1 A
11,8 / 10,5 V
1380 g
207 x 217 x 61 mm
1)
33