Lubrication - Makita XSJ01 Manuel D'instruction

Hex wrench storage
009021
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
009015
OPERATION
009020
1
2
3
4
009018
1. Hex wrench
1
1. Hook
1. Side blade
2. Side blade
surface
3. Center blade
4. Workpiece
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece surface.
Adjusting shear blade
1
2
3
4
009019
Adjust the side blade L so that the curl of waste material does
not contact the cutting head or the workpiece. Use the hex
wrench to loosen the three screws which hold the cutting
head. Move the side blade L back and forth to adjust it. Then
tighten the three screws with the hex wrench.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Lubrication

1
2
3
5
4
009022
Before operation, lubricate the contact point of the center
blade and the side blades R/L. And, also lubricate the
point of the center blade near the cutting head. To keep
good cutting performance, use lubricant from time to time
during operation.
7
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
5
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Lubricate