Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Selecting the action mode
1
008351
This tool employs an action mode changing ring. Select
one of the three modes suitable for your work needs by
using this ring.
For rotation only, turn the ring so that the arrow on the
tool body points toward the
For rotation with hammering, turn the ring so that the
arrow points toward the
For rotation with clutch, turn the ring so that the arrow
points toward the
mark on the ring.
CAUTION:
Always set the ring correctly to your desired mode
•
mark. If you operate the tool with the ring
positioned halfway between the mode marks, the
tool may be damaged.
Adjusting the fastening torque
1
008351
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that its graduations are
aligned with the arrow on the tool body. The fastening
torque is minimum when the number 1 is aligned with
the arrow, and maximum when the number 16 is aligned
with the arrow.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
1. Action mode
changing ring
2. Adjusting ring
2
3. Graduation
3
4. Arrow
4
mark on the ring.
mark on the ring.
1. Action mode
changing ring
2. Adjusting ring
2
3. Graduation
3
4. Arrow
4
Installing or removing driver bit or drill bit
008352
Turn the sleeve counterclockwise to open the chuck
jaws. Place the bit in the chuck as far as it will go. Turn
the sleeve clockwise to tighten the chuck.
To remove the bit, turn the sleeve counterclockwise.
Installing bit holder (accessory)
1
2
007470
Fit the bit holder into the protrusion at the tool foot on
eithher right or left side and secure it with a screw.
When not using the driver bit, keep it in the bit holders.
Bits 45 mm (1-3/4") long can be kept there.
Hook (Accessory)
008410
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
6
1. Sleeve
1
1. Bit holder
2. Bit
1. Groove
2. Screw
1
3. Hook
3
2
Publicité
Table des Matières
