EIBENSTOCK EBM 352/3 Notice Originale page 120

Behavior by Malfunction
Turn off the machine by malfunction and disconnect from the
electricity network. Operations on the electrical system of the
machine can be executed only by a specialist.
Trouble Shooting
malfunction
Drill unit has to
much play
(vibration)
According to the general supply conditions for business dealings, suppliers have
to provide to companies a warranty period of 12 months for redhibitory defects. (to
be documented by invoice or delivery note)
Damage due to natural wear, overstressing or improper handling are excluded
from this warranty.
Damages due to material defects or production faults shall be eliminated free of
charge by either repair or replacement.
Complaints will be accepted only if the tool is returned in non-dismantled condition
to the manufacturer or an authorized Eibenstock service centre.
Declaration of Conformity
It is necessary that the machine (f. e. EBM 352/3) used in this drill rig comply with
the requirements which are described in the specifications of the drill rig (f. e.
drilling diameter, fixture of the motor).
We declare that this unit has been designed in compliance with 2006/42/EC.
This unit must not be put into service until it was established that the Power Tool
to be connected to this unit is in compliance with 2006/42/EC (identified by the
CE-marking on the Power Tool).
Vakuum Technik GmbH Eibenstock
Lothar Lässig
20.04.2012
possible cause
stand has been loose
guidance has to much play
thrust sliding balls
Warranty
repair
adjust the wing nut
adjust guidance (see page 19)
replace the sliding balls
20
.