EIBENSTOCK EBM 352/3 Notice Originale page 118

Lay the power cable in such a way that any damage by the drill can be
avoided.
Make sure to always keep the work area in view and to be able to reach all
necessary operating elements and safety installations.
Keep other persons away from your work area in order to avoid accidents.
Space requirements for operating and maintenance
Whenever possible, keep a free space for operating and maintenance of about 2
m around the drill position, so that you can work safely and have immediate
access in case of a failure.
At the beginning, drill very slowly, since the drill bit does only starts cutting with a
fraction of the cut surface in the material. If you drill too fast or with too much
pressure, the drill bit could get jammed.
Angled drilling
2
1
3
Drilling with Water
If you are cooling the drill bit with water a water collection ring is recommended.
This will be mounted with a latch fastener on the screws of the base plate and
ensures a clean drilling. Mainly for overhead or lateral drilling. (see spezial-
accessories page 13).
Drilling
The scale on the toothed column makes
adjusting the drilling angle easier.
Remove the screw (1), which locks the
pillar at 90° .
Loosen the two side screws (2) on the
base plate.
Loosen the clamp (3) on the support with
the help of the feed lever.
Now turn the column until the desired
angle.
Tighten the 2 screws (2) and the clamp (3)
again.
18