Table des Matières
Publicité
SIGNODE BXT2-19
2
Fig. 9
1
Fig. 10
1
➟
+ / -
Fig. 11
1
2
AUTO
➟
MAN.
SOFT
A)
1
2
3
4
1200 1550 1900 2250 2600 2950 3300 3650 4000 N
264
341
418
496
B)
1
2
3
4
400
550
700
850 1000 1150 1300 1450 1600 N
88
121
154
187
Fig. 12
18
1
3
2
2
3
=
AUTO
AUTO
=
MAN.
MAN.
SOFT
SOFT
3
5
6
7
8
573
650
727 804 882 lbs.
5
6
7
8
220
253
286 319 353 lbs.
For Parts & Service 1-877-862-6699
5.3 CHECKING THE SEAL
– Check appearance of seal (see fig. 9) regularly. If the
straps are poorly welded, check the welding time
setting (refer to chapter 5.7).
1 Good seal (the complete surface is cleanly welded
without excess material being forced out sideways).
2 Poorly welded seal (not welded over the complete
surface), welding time too short.
3 Poorly welded seal (excess material is forced out
sideways), welding time too long.
5.4 CHECKING BATTERY CHARGE
– Read off battery charge on LED indicator (Fig. 10):
1 = Green indicator: maximum battery charge
3
2 = Green indicator: good battery charge
3 = Red indicator: empty battery
(Battery must be charged)
5.5 SETTING STRAP TENSION
– Press the „Function" button (11/1) briefly.
– Press the „Strap tension" button (11/2) until the
flashing digital display (11/3) shows the required strap
tension. Wait two seconds until the new setting is
saved.
1 = min. strap tension approx. 400/1200 N*
(88/264 lbs.) (PP)
9 = max. strap tension approx. 1600/4000 N*
(353/882 lbs) (PET)
* refer to Chapter 5.7
5.6 SETTING SOFT TENSION
AUTO
The following two strap tension ranges can
MAN.
be set on the tool:
A = 1200–4000 N (264–882 lbs.)
SOFT
standard, PET straps
B = 400–1600 N (88–353 lbs.)
Soft tension*, PP straps
* Soft tension: tension wheel starts slowly. Prevents
9
excessive dirt on PP straps.
Setting soft tension:
– Press the „Function" button (12/1) briefly.
9
– Press the „Mode of operation" button (12/2) several
times until the green „SOFT" LED indicator (12/3)
lights up together with the desired mode of operation
(refer to chapter 5.5).
07.15
Publicité
Table des Matières
Dépannage
