Makita HU01 Manuel D'instruction page 11

Removing or installing hedge shear blades
CAUTION:
Before removing or installing shear blades, always
•
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
•
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
Removing the hedge shear blades
1
010890
CAUTION:
Install the blade cover before removing or
•
installing the shear blades.
Reverse the tool.
1
4
010891
To remove the shear blades, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
1. Blade cover
1. Undercover
2
2. Locking lever
3. Press
3
4. Turn
on the undercover
on the locking lever.
1
010892
Take out the undercover from the tool.
010893
Loosen two screws with a coin and similars and remove
the shear blades.
NOTE:
Do not remove the screws. Without removing the
•
screws loosened, shear blades can be removed.
1
010894
Remove the crank from the shear blades.
NOTE:
The crank may remain in the tool.
•
11
1. Undercover
1. Screws
1
1. Crank
2. Shear blades
2