Special Warnings When Using This Log Splitter - Texas Power Split 370 H Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
 Always keep the user manual together with the machine.
 Make sure that your hands are kept away from the log and wedges all the time. Never
touch the moving parts when the machine is on.
 The log splitter must only be operated by persons who are rested and in good shape.
If the work is exhausting remember to take breaks on a regular basis. Never use the
machine under influence of alcohol, drugs or medication.
 Before start always check that bolts and nuts are fastened.
 Always disconnect the power of the log splitter before performing service or replacing
parts.
 Before start always check that bolts and nuts are fastened.
 Never try to split logs larger than the recommended log size capacity. Logs must be
free from nails or wires, which may fly up or damage the machine. The log must be cut
square in the end and remove also all branches from the trunk. Always cut the log in
direction of its grain. Do not place the log across the splitter it may damage the
splitter.
 Never force the log splitter in more than 5 seconds with the cylinder under pressure
when you try to cut excessively hard wood. Overheated oil may damage the machine
under pressure. Stop the machine. Rotate the log 90 degrees and try again. If the
wood still cannot be split it means that the wood's hardness exceeds the capacity of
the machine and it must be rejected in order not to damage the log splitter.

Special warnings when using this log splitter

Hydraulic systems.
Never use the machine if there is a leakage in the hydraulic system. Before using the log
splitter, check for hydraulic leaks. Be sure that the tool and your work area is clean and
free of oil spills. Hydraulic fluid can create hazards causing you to slip and fall, your hands
to slip while using the machine or cause a fire hazard.
Electric safety.
Never operate the machine if there is a fault in the electric system. Never operate a log
splitter in wet conditions. Never operate this tool with an improper electrical cord or
extension cord. Never operate this tool unless you are able to plug it into a properly
grounded outlet which supplies power as stated on the type tag and is protected by a 16
Amp circuit disconnector.
Physical dangers.
Log splitting creates special physical hazards. Never operate this tool unless you are
wearing proper safety gloves, hard-toed shoes and approved eye protection etc. Watch
out for splitters in order to avoid puncture, injury and jamming the tool. Never try to split
logs which are too large or small to fit properly into the tool. Never attempt to split logs
containing nails, wires or other debris. Clean up as you work, accumulated split wood and
wood chips can create a hazardous work environment. Never continue to work in a
24

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Power split 500 hPower split 520 h

Table des Matières