Making The Log Splitter Ready; Starting And Maintenance; Oil; Recommended Hydraulic Oil - Texas Power Split 620 V Manuel D'instruction

Logsplitter with 230 V engine acquires 16
amperes.
Logsplitter with 380 V engine acquires 10
amperes.
If any doubts please consult a qualified
electrician. Do not attempt any electrical
repairs yourself.

Making the log splitter ready

Remove the log splitter from its packing
and lubricate the splitting head by its
plastic edge.
The splitting plate can be adjusted in 3
heights.
On both sides of the handles arms have
been mounted to fasten the logs when
the piston moves back.
Mounting of the wire at the inlet.
Push the red safety stop button back and
the lid can be opened.
Hereinafter the machine can be started
when the safety button is pressed down,
the machine stops.

Starting and maintenance

Lubricate with some oil in the piston
tunnel on all 4 sides.
Lubricate also with some oil on the 4 top
sides.
Lubrication shall be repeated after every
4 cubic meters.
Also remember to inspect the oil level in
the tank.

Oil

The oil level is checked by the means of
the red oil stick.
Oil type for supplement: hydraulic oil.

Recommended hydraulic oil

We recommend the following oil to the
hydraulic cylinder: Texamatic 7045,
viscosity 33,8. Art. no. 90306479.
Or oil with corresponding viscosity

Operation

Recommended size of logs to be split

The diameter of the log is only indicative.
A small piece of wood can be difficult to
split if it has knots or if its fibres are very
tough. A larger piece of wood can be split
if its fibres are smooth and loose.
Never force the log splitter to split more
than 5 seconds with the cylinder under
pressure in order to split excessively hard
wood. Overheated oil under pressure
may damage the machine. It is very
important that if the log splitter does not
split in the first attempt, please stop the
machine and rotate the log 90 degrees. If
the wood still cannot be split, it means
that the hardness of the wood exceeds
the capacity of the machine and it must
be rejected in order not to damage the log
splitter.
When splitting both handles shall be used
as shown on picture.
Variable splitting length from 10-105 cm.
Height is adjusted by pushing down both
handles (vertically) to the requested size
of wood. Here you let go of one of the
handles (shown with arrow) Loosen the
knurled nut (shown) and the bar
indicating the height is pulled up and the
knurled nut is refastened (shown).
4-head wedge can be purchased as an
extra accessory.
14