Overview; Installation; Dmx-512 Connection - EuroLite DMX Split 6X Mode D'emploi

4.2 Overview

Front panel
1. POWER ON/OFF
Press this button to start operation.
2. DMX OUT-SOCKETS
3- and 5-pin XLR-plug
3. LINK OUT/TERMINATE-SWITCH
Rear panel
4. DMX IN-SOCKETS
3- and 5-pin XLR-plug
5. DMX OUT-SOCKETS
3- and 5-pin XLR-plug
6. AC CONNECTION

4.3 Installation

Install the device on a plane surface or install it in a rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the device into the rack, please make sure that there is enough space around the device so
that the heated air can be passed on. Steady overheating will damage your device.
You can fix the device with four screws M6 in the rack.

4.4 DMX-512 connection

The DMX-splitter can either be connected directly to the lighting controller or after a series of DMX-devices.
You can connect up to 31 DMX-devices to every DMX output socket.
If you connect the splitter after a DMX-device the number of DMX-devices before the splitter must not
exceed 31.
14/28 70064820_V_1_0.DOC